Once a year the "double 11" shopping Carnival finally opened the curtain, as Tmall, Gome, Suning represented by commercial enterprises have issued a report, in addition to the excitement of the data PK, this year eleven and no other. At this time of the year, logistics Express is the most laborious, overtime all night, such as the mountain parcels pile up, let the people breathless.

Similar to the large logistics goods sorting center, there are many especially People are hurrying to and fro. easily, causing the dust flying everywhere, a large number of staff was inhaled, cause serious harm, clean up is also very troublesome, now basically like the workplace, basically will use floor paint to solve these problems.

In this environment the floor, Kailin paint primer recommended closure using epoxy topcoat, bridge resistant epoxy floor paint, not only can prevent dust pollution, easy to clean, on the cement floor can also play a very good protective effect, greatly increasing the service life of cement. Under the bridge epoxy wear-resistant floor paint construction supporting as an example, to introduce the construction of epoxy floor lacquer for you.

1. Ground handling:

The base surface should be smooth, solid, clean and dry, water content is less than 4%, surface mortar, soil, oil pollution and dust should be treated clean.

Primer：

Two. The primer of primer is epoxy osmosis primer, 15KG/ barrel, curing agent is H-T50 curing agent, 3KG/ listening, and the ratio is 5:1. First, the main agent is evenly stirred, adding proper amount of curing agent, fully stirring evenly, standing for a few minutes, then the main agent and curing agent are fully integrated and solidified, then add 15%-20% diluent, stir evenly, and stand for 10 minutes or so, and then proceed construction. Roll or brush, fully moisten the base surface, and penetrate into the inner layer of the base material. After curing for 24 hours, the finish can be made.

Topcoat:

The main agent of epoxy abrasion resistant floor paint is epoxy wear resistant floor finish (all kinds), 12KG/ barrel, curing agent is epoxy abrasion resistant floor finish (curing agent), 12KG/ barrel, the ratio is 1:1. The use of the paint is the same as the primer, and it should be well stirred and used. Use roll coating, spray or scraper to brush 2. (second lacquer can be painted after the first watch).

Note: how much the paint is used, how to adjust the whole barrel paint at a time, because the paint with curing agent will usually solidify in 4-6 hours. If the paint is not used up, it must not be poured into the original paint, otherwise the whole barrel will be scrapped.